<menu id="o62w2"><label id="o62w2"></label></menu><input id="o62w2"><sup id="o62w2"></sup></input>
  • <object id="o62w2"></object>
  • 瑞晨建材
    電話:0571-56017206
    電話0571-88755169

    新聞中心

    電話:0571-56017206

    傳真:0571-85853340

    地址:杭州市余杭區余杭鎮義橋工業園區

    當前位置:首頁 > 新聞中心 > 行業資訊行業資訊

    金屬天溝雨水管:鋼天溝下垂處理方法
    文章來源:www.rgukz.com  作者:瑞晨建材  更新時間:2018-08-14 16:03:22  Tag:金屬天溝雨水管  瀏覽:13
      在鋼天溝的施工中有時會發現:由于柱距較大而天溝厚度較小時,就會發生天溝下撓的現象。根據我們臨安瑞晨建材有限公司落水系統廠家的經驗來看,主要有以下解決方法:
     
      In the construction of steel gutter, it is sometimes found that when the distance between columns is large and the thickness of gutter is small, the phenomenon of gutter deflection will occur. According to the experience of the falling water system manufacturer of Linan Ruichen Building Materials Co., Ltd, there are mainly the following solutions:
    金屬天溝雨水管
      一、在天溝下設通長的系梁兼做天溝的支撐,以保證其不會下垂,或者下面做支托。最好焊天溝時,中間起坡大一點,安裝時,盡量避免在天溝中行走,以免下撓。
     
      1. Under the Tiangou, a long tie beam is used as the support of the Tiangou to ensure that it does not sag, or underneath as a support. It is better to weld the groove, the middle slope a little larger, installation, as far as possible to avoid walking in the groove, so as to avoid deflection.
     
      二、用焊接組合的天溝,天溝中部向兩端起拱一定的坡度就可以徹底解決這個問題,但是非曲直必將造成天溝的加工費用增大。
     
      2. The problem can be solved thoroughly by using the welded groove to arch the middle part of the groove to both ends with a certain gradient, but the Non-curvature of the groove will inevitably increase the processing cost.
    推薦閱讀新聞:
  • 金屬天溝雨水管:鋼天溝下垂處理方
  • 關于彩鋁落水系統的特點詳細概述
  • 金屬雨落水系統實用性與裝飾性兼具
  • 瑞晨落水系統優良的品質和環保性能
  • 落水管安裝需要考慮到的方面
  • 落水管開槽有哪些注意事項
  • 落水管的安裝和連接
  • 11选5任3必中计算方法